AMD 120 DIP BLOCKED CHUTE / LEVEL SWITCH

Specification of the Blocked Chute Switch

For use on free flowing materials at atmospheric pressure. The AMD 120 can eliminate spillage and expensive cleanups in cases of Bin overflow or conveying blockages.
Dependability and low cost are synonymous with the AMD 120.

For best results and sensitivity, connect with a 20mm conduit to allow the dissipation of displaced air in the housing caused by the movement of the diaphragm.

Specification:
Blocked Chute/Level Switch IP65
(DIP Aus Ex 3677  Certificate expired)
NOTE: Only suitable for use in a Hazardous Area (DUST) when supplied by an IS Barriers as a simple device, please contact your supplier for further clarification if required.

Aluminium Casting
Faceflange is 304 Stainless Steel
Fully Gasketed – it is both weather
and dust proof
Hard wearing diaphragm
Temperature to 110 Deg. C.
Two wire circuit N/O or N/C SPDT.
Voltage 12V to 240V. Rated 2 Amps
Sensitivity Adjustment.
Electrical Conduit Entry – 20mm.
Mounting is 6 x 6mm on 154 PCD
Bin cutout is 110 mm.
Shipping weight is 1.5 kgs.

AMD-WMF Mounting Flange

MAT,L 4mm PLATE MS ZINC PLATED
SUPPLIED WITH 6 OFF M6 X 30 SET SCREWS ZINC PLATED

INSTALLATION

CUT HOLE Ø 130 IN CHUTE AND WELD WMF FLANGE
IN PLACE THEN MOUNT AMD 120 SWITCH